CASE STUDY

[India] With our existing multimeters, we frequently experienced issues with erroneous readings, which reduced the reliability of electrical diagnostics during powertrain testing and sometimes even led to misleading conclusions. In addition, the manual range-selection knob required us to repeatedly switch between voltage ranges during testing, making the process slow and cumbersome, and significantly decreasing our overall efficiency.

[Syria] We faced time-consuming measurements due to the need for manual range selection, as well as difficulty working in tight spaces (e.g., in crowded electrical panels). Additionally, we sometimes experienced concerns about accuracy and safety with our old equipment.

[Saudi Arabia] I have been struggling with lower-quality measuring instruments that provide unstable readings in high-temperature and high-humidity environments. I often had to repeat tests multiple times to feel confident in the results, which wasted time on-site. I previously used instruments with poor ergonomics and weak cable connections. In tight electrical panels, common clamp meters were difficult to handle.

[Japan] Cables are crowded in the distribution board and power distribution board and we couldn't clamp the target cables. There's no space to put the clamp jaws into the crowded area.

[Japan] When testing transducers (convertors) in a distribution board, there are cases where the central monitoring system cannot be started up. In such situations, the output wiring of the transducer was disconnected and a digital multimeter was connected for measurement.  Similarly, when abnormal readings appeared on the central monitoring system on a board in operation, disconnecting the transducer output wiring during operation posed a high risk. Therefore, transducer testing was carried out during scheduled power outages to check for any malfunctions.

【Indonesia】 Multiple testers are required to check the power of a busbar (80x10 mm) or in cable crowded area. I've been worried about touching with a busbar adjacent to the cable I wish to clamp.