CASE STUDY

[Lithuania] Before introducing the Kyoritsu KEW 6305, we had problems with electrical measurements because we used old instruments with limited functions. We often needed several devices and setups to get the overall situation, which made troubleshooting slow, and sometimes unstable issues were missed and not caught. Measurement accuracy was not always consistent, especially with changes in load. Also, setup in different locations took too much time and slowed down our daily testing work.

[Spain] I previously required at least two or three different instruments to simultaneously perform power measurements, waveform visualization, and harmonics analysis.

【Indonesia】 Multiple testers are required to check the power of a busbar (80x10 mm) or in cable crowded area. I've been worried about touching with a busbar adjacent to the cable I wish to clamp.

【Japan】 Just the selling points of our energy saving products aren't enough to convince our customer to purchase our products. Wondering if it is possible to quantify the power consumption and offer the data to stimulate their purchase intention?