2413R KYORITSU

Leakage Clamp Meters

2413R

Selection Guide

•	Large transformer jaws of 68mm diameter makes it possible to clamp on all three or four wires (3 phases) together for leakage current measurement.
•	True RMS enables an accurate measurement for distorted waveforms.
•	Measurement from mA up to AC 1000A
•	Frequency filter switch to eliminate the effect of the harmonics.
•	2 way analogue output terminal: AC current detected by transformer jaws is converted to AC and DC voltage. Output cord model 7073 (option) is used for monitoring waveform with an oscilloscope or for connecting to a recorder.

AC A
(50/60Hz)

200mA/2/20/200/1000A
|±2.5%rdg±5dgt (200mA/2/20A)
|±3.0%rdg±5dgt (200A, 0~500A)
|±5.5%rdg (501~1000A)

AC A
(WIDE)

200mA/2/20/200/1000A
|±1.8%rdg±5dgt (50/60Hz) (200mA/2/20A)
|±2.0%rdg±5dgt (50/60Hz) (200A, 0~500A)
|±5.0%rdg (50/60Hz) (501~1000A)

Conductor Size

Ø68mm max.

Frequency Response

40Hz~1kHz

Output

Waveform :	AC200mV against the maximum value of each range (1000A range is 100mV)
Recorder :	DC200mV against the maximum value of each range (1000A range is 100mV)

Crest Factor

3.0 or less

Withstand Voltage

3700V AC for 1 minute

Applicable Standard

IEC 61010-1 CAT.III 300V Pollution degree 2
IEC 61010-2-032

Power Source

6F22 (9V) × 1 *Continuous measuring time: Approx. 60 hours

Dimensions

250(L) × 130(W) × 50(D)mm

Weight

Approx. 570g (including battery)

Accessories

9094 (Carrying Case)
6F22 × 1
Instruction Manual

Optional

7073 (2WAY Output Cord)

| | |