KYORITSU
HOME

PRODUCTS
   • Multimeters
   • Voltage Testers
   • Clamp Meters
   • Loggers
   • Insulation Testers
   • Earth Testers
   • LOOP/PFC/PSC
     Testers
   • RCD Testers
   • Multi Function Testers
   • Portable Appliance
     Testers
   • Power Meters
   • Sensors, Multi-Trans,
     Clamp Adaptors
   • Others
   • Accessories
   • Discontinued Products

 
AC/DC Clamp Sensor

KEW 8115
   
 
Permits extension of the AC and DC current ranges of almost any Digital Multimeters (DMMs) without breaking the circuit under test.
Using KEW 8115 with KEW 1051/1052 (DMM) the display can be set for direct reading in A.
8115

CE
   
 
Measuring range AC 0.1 - 130Arms (185Apeak) DC 0 - ±180A
Output voltage AC 10mV/A DC 10mV/A
Accuracy ±1.2%rdg±0.4mV (50/60Hz)
±2.5%rdg±0.4mV (40 - 1kHz)
±1.2%rdg±0.4mV (*)
Low battery warning 2.2V±0.2V or less - Red LED flash
(1.9V±0.2V - Automatically power off)
Conductor size Max. Φ12mm
Withstand voltage AC 3540V (RMS 50/60Hz) for 5 sec.
Operating temperature & humidity range -10 to 55ºC, relative humidity 85% or less (no condensation)
Output impedance Approx. 10Ω or less
Applicable standards IEC 61010-1 CAT III 300V Pollution degree 2,
IEC 61010-2-032, IEC 61326-1
Power source DC3V (size AAA alkaline battery LR03×2pcs)
* Continuous use: approx. 40 hours
(Auto power off: approx. 20 minutes)
Cord length Approx. 1,200mm
Output connector Φ4mm banana plug
Dimensions 127(L)×42(W)×22(D) mm
Weight Approx. 140g
Accessories Soft case, LR03×2, Instruction manual
* This accuracy is defined after the completion of the Kew 8115 zero-adjustment whilst connected to a DMM.

PageTop

Copyright(c)2004 KYORITSU ELECTRICAL INSTRUMENTS WORKS, LTD. Sitemap | Contact Us | Terms of Use | Privacy Policy